myCNC - CNC control, CNC software, CNC electronics
|
We are working on G65 code implementation which allow to work with parameterized macros. G65 code runs macro program with number, programmed in P parameter.
Up to 21 local variables could be sent to the macro through A-Z parameters. In a screenshot is shown peck drilling cycle (G83) repeated in a line by running G65 with macro O9911.
Number of drills is programmed by H parameter; distance between drills programmed by U parameter; line angle angle programmed by A parameter. Listing of nc program is below: %
(XY - position)
(U - distance between points)
(A - angle)
(H - number of points)
G83 Z-10 Q2. R0.5 L0
G65 P9911 X10 Y20 A30 U10 H5
M30
%
|
|
|
myPlasma coming soon. myPlasma is control system kit to build Plasma Power source, based on chopper IGBT technology (step-down converter). myPlasma kit includes: - myPlasma control board - ARM Cortex M3 microcontroller based board, that runs complete control of Plasma Power source
- 4 channel PWM control;
- 2 channel Plasma current sensor measure;
- 2 channel Plasma voltage measure;
- 5 channel GPIO binary inputs (optoisolated);
- 6 channels relay outputs;
- optoisolated RS485 bus channel for connection to CNC machine;
- USB connector for programming/configuration;
- Driver boards for power IGBT module with opto-isolation;
- Relay board;
- LED indicator board with keys/encoder for Current setup;
- Closed-Loop Hall-based ultra-fast Current Sensor (made by Honeywell);
- Power IGBT modules (made by Semicron);
- Frequency ignition unit (on demand);
Main features: - Soft plasma ignition;
- Current range from 25A;
- Tested solution to build power sources for Current - 130, 160, 260, 320 Amps;
- 400 Amps power source is under developing;
- Complete integration with myCNC control system;
- Automatic or Manual gas console compatible;
|
|
|
|